We offer the option of a new virgin barrel, or a barrel kit with Geissel gas block pinned.
The stripped barrel is simply that: a new Daniel Defense barrel. The option with a Geissele gas block and your choice of with or without a gas gas tube. If you choose the gas tube option, the gas tube will be installed into the gas block and with a gas tube roll pin. The pinning of the gas block is delivered partially in-place, to allow you to remove the gas block and slide on a barrel nut to match your choice of rail. The Geissele gas block will work well with a Daniel Defense RIS-II M4A1 rail for a Block 2 build, as well as with any Geissele rail, like the Mk8, Mk14 or Mk16 Geissele rails.
Cold Hammer Forging of barrels has been known for decades to produce the most accurate, longest lasting rifle barrels obtainable. The Cold Hammer Forging of barrels is accomplished through intense hydraulic pressure applied at opposing angles by carbide steel hammers. During the hammering process, a mandrel is inserted into the bore while the carbide steel hammers shape the barrel around the mandrel creating the chamber, the lands, and the grooves. In addition to the aforementioned benefits, the Cold Hammer Forging process creates a defect free bore and the most consistent chamber possible.
All Daniel Defense cold hammer forged barrels are made from start to finish in our state-of-the-art facility located in Black Creek, GA. In keeping with our heritage of not cutting corners, all cold hammer forged barrels feature a forged chamber and highest quality exterior coating. These barrels will prove themselves to be more accurate and last longer than a barrel that has cut or button rifling.
The barrels have been taken off of Daniel Defense full upper receiver assemblies or rifles, or off of Geissele upper receiver assemblies, and might have dimples for low profile gas blocks, or pin holes through the barrel from previous DD or Geissele gas blocks.
| Caliber | 5.56mm NATO | |
|---|---|---|
| Barrel Length | 14.5" | |
| Manuf. Process | Cold Hammer Forged | |
| Twist Rate | 1:7 | |
| Muzzle Thread | 1⁄2×28 TPI (Threads Per Inch) | |
| Material | Chrome Moly Vanadium | |
| Outside Finish | Mil-Spec Heavy Phosphate | |
| Inside Finish | Chrome | |
| Gas System | Mid-length | |
| Diameter At Gas Port | .750″ | |
| Barrel Extension | M4 | |
| Barrel Profile | Government (not M4) | |
| Weight |
|
|
| Condition | New, either in factory tube or VCI blue plastic |
All Daniel Defense cold hammer forged barrels are made from start to finish in our state-of-the-art facility located in Black Creek, GA. In keeping with our heritage of not cutting corners, all cold hammer forged barrels feature a forged chamber and highest quality exterior coating. These barrels will prove themselves to be more accurate and last longer than a barrel that has cut or button rifling.
Once this part is assembled into a complete firearm, it becomes a regulated item by the National Firearms Act (NFA). Please check with your local and state municipalities for any further regulatory requirements. It is the buyer’s responsibility to make sure they comply with all NFA rules and applicable laws.
Daniel Defense
Daniel Defense
