11.5" 5.56MM, carbine gas, 1:7, Government profile, CMF, CMV chrome-lined
This is a factory new Daniel Defense barrel
Cold Hammer Forging of barrels has been known for decades to produce the most accurate, the longest lasting rifle barrels obtainable. The Cold Hammer Forging of barrels is accomplished through intense hydraulic pressure applied at opposing angles by carbide steel hammers. During the hammering process, a mandrel is inserted into the bore while the carbide steel hammers shape the barrel around the mandrel creating the chamber, the lands, and the grooves. In addition to the aforementioned benefits, the Cold Hammer Forging process creates a defect free bore and the most consistent chamber possible.
All Daniel Defense cold hammer forged barrels are made from start to finish in our state-of-the-art facility located in Black Creek, GA. In keeping with our heritage of not cutting corners, all cold hammer forged barrels feature a forged chamber and highest quality exterior coating. These barrels will prove themselves to be more accurate and last longer than a barrel that has cut or button rifling.
ADDITIONAL INFORMATION
| Caliber | 5.56mm NATO | |
|---|---|---|
| Barrel Length | 11.5" | |
| Manuf. Process | Cold Hammer Forged | |
| Twist Rate | 1:7 | |
| Muzzle Thread | 1⁄2×28 TPI (Threads Per Inch) | |
| Material | Chrome Moly Vanadium - 4150 | |
| Outside Finish | Mil-Spec Heavy Phosphate | |
| Inside Finish | Chrome Lined | |
| Gas System | Carbine | |
| Diameter At Gas Port | .750″ | |
| Barrel Extension | M4 | |
| Barrel Profile | Government (not M4) | |
| Weight |
|
|
| Condition | New, either in factory tube or VCI blue plastic |
All Daniel Defense cold hammer forged barrels are made from start to finish in our state-of-the-art facility located in Black Creek, GA. In keeping with our heritage of not cutting corners, all cold hammer forged barrels feature a forged chamber and highest quality exterior coating. These barrels will prove themselves to be more accurate and last longer than a barrel that has cut or button rifling.
Note: No barrel nut included. Will need mil-spec barrel nut if installing with polymer handguards. Rail system will normally have its own barrel nut, but the FSB will need to be removed for the barrel nut installation.
When purchasing this barrel, you may also want:
- Colt Carbine Length Gas Tube and roll pin
- Colt Delta Ring Assembly required if you want to mount any of the following.
- Colt M4 Double-Insulated Carbine Handguard
- KAC M4 RAS with 3 Ribbed Panels
- Magpul MOE SL M-LOK Hand Guard, Carbine Length, Black
- Magpul MOE M-LOK Hand Guard, Carbine Length, Black
- Magpul MOE M-LOK Hand Guard, Carbine Length, FDE
NFA DISCLAIMER
Once this part is assembled into a complete firearm, it becomes a regulated item by the National Firearms Act (NFA). Please check with your local and state municipalities for any further regulatory requirements. It is the buyer’s responsibility to make sure they comply with all NFA rules and applicable laws.
